Battery Check - Olympus C-3020 Zoom Reference Manual

Loading the batteries (Cont.)
7

Battery check

If remaining power is low, the battery check indication on the control panel
starts blinking when you turn on the power or while you are using the camera
as follows.
Lights.
Remaining power
level: high
● After taking a picture or when turning on the power with batteries that
are running low, the camera may emit several short beeps and the
number of storable pictures will blink. If this happens, the picture just
taken will not turn out properly. Replace the batteries and take the
picture again.
● If the terminals inside the battery compartment are dirty, it will noticeably
shorten the life of the batteries. Do not touch the inside of the battery
compartment.
● If the camera is left for 1 hour with the batteries removed, all the internal
settings will revert to the default settings.
26
Close the battery compartment cover, then
press it down and slide it in the opposite
6
direction of the arrow printed on it.
● When pressing the battery compartment
cover shut, be sure to press the center of
the cover, as it may be difficult to close
properly by pressing the edge.
● Make sure the cover is completely closed.
Slide the battery compartment lock on
the battery compartment cover in the
direction of
8
Blinks.
Remaining power level:
low. Replace with a new
battery.
.
Turns off after blinking for
approx. 10 sec.
Remaining power level: exhausted.
Replace with a new battery.