Olympus C-3020 Zoom Reference Manual page 189

Troubleshooting (Cont.)
POSSIBLE CAUSES
No picture is taken when the shutter button is pressed.
7 The batteries ran out of
power.
8 The control panel/
monitor indications
disappear, or only the
battery check blinks.
9 A write-protect
adhesive seal is placed
on the card or there is
no card in the camera.
The date recorded with the image data is wrong.
1 The date is not set.
2 The camera has been
left for approx. 1 hour
with the batteries
removed and the date
setting is canceled.
1 The flash is set to the
off mode.
2 The subject is in bright
light.
3 Sequential shooting
and Auto bracketing
BKT are on.
4 You are recording
movies.
CORRECTIVE ACTION
7 Replace the batteries with
new ones.
8 Replace the batteries with
new ones. (Do not open the
battery compartment cover
when the card access lamp
is blinking.)
9 Insert a new card in the
camera.
1 Set the date. (The clock
adjustment is not factory-
preset.)
2 Set the date again.
The flash does not fire.
1 Press the
a flash mode other than
2 Set the flash to Fill-In mode.
3 Set DRIVE to
menus.
4 Set the shooting mode to
any mode other than the
Movie mode.
button to select
.
in the
~
Continued on next page
REF. PAGE
P. 25
P. 25
P. 29
P. 32
P. 32
P. 88–91
P. 88
P. 98
P. 64
189