Mode; Destination (Dest); On Value (Onval); Off Value (Offval) - Kurzweil Artis SE Musician's Manual

Multi Edit Mode
The Zone-specific Parameters
• SW2 Button
The following are parameters that affect the behavior of the Pedal Switch and Sw button
controllers.

Mode

The Mode parameter determines the switching action of the switch controllers. You can set
this parameter either of three settings:
Momentary
Toggled

Destination (Dest)

The Destination parameter determines the Controller Destination for the currently selected
controller in the currently selected Zone. For a list of the Multi Destination Controllers and
their descriptions, see Destination (Dest) on page 8-11.

On Value (OnVal)

The On Value is the MIDI value sent when the switch is set to On. You can set this
parameter to any number between 0 and 127, or to None.

Off Value (OffVal)

The Off Value is the MIDI value sent when the switch is set to Off. You can set this
parameter to any number between 0 and 127, or to None.

Entry State

The Entry State parameter determines the state of the switch controller that is sent as a MIDI
message when the current Multi is loaded. You can set this parameter to None, On, or Off.
If Entry State is set to None, when you load the current Multi the controller will be at
whatever value it last had in that MIDI channel.

Exit State

The Exit State parameter determines the state of the Pedal Switch that is sent as a MIDI
message when the current Multi is exited. You can set this parameter to None, On, or Off.
If Exit State is set to None, then when you leave the current Multi the controller will be at
whatever value it last had in that MIDI channel.
8-14
A momentary switch is one that is only in the "on" state when it is
pressed. As soon as you release the switch, it goes into the "off" state.
A toggled switch is one that maintains its state after it is pressed. So, if
the switch is currently in the "off" state, pressing it once will put it in the
"on" state. Pressing it again will put it back in the "off" state.