Controlling Program Parameter Assignments From Multi Mode; Entry Value; Exit Value; The Pedal Switch & Switch Button Parameters - Kurzweil Artis SE Musician's Manual

Controller
Number
137
138
139
140
141
142
143
144
145
146

Controlling Program Parameter Assignments from Multi Mode

Commonly you will want to assign a physical controller in a Multi to control the same
Program parameter that it controlled in Program Mode. In the Dest parameter list,
destinations that are assigned to parameters for the Program of the current Zone will show
the Program Parameter name instead of that Controller Destination's default name. Select
one of these destinations to control an assigned Program parameter.

Entry Value

The Entry Value parameter determines the value of the continuous controller that is sent as a
MIDI message when the current Multi is loaded. You can set this parameter to any number
between 0 and 127, or to None.
If Entry Value is set to None, when you load the current Multi the controller will be at
whatever value it last had in that MIDI channel.

Exit Value

The Exit Value parameter determines the value of the continuous controller that is sent as a
MIDI message when the current Multi is exited. You can set this parameter to any number
between 0 and 127, or to None.
If Exit Value is set to None, then when you leave the current Multi the controller will be at
whatever value it last had in that MIDI channel.
The Pedal Switch & Switch Button Parameters
• PdSw1a
• PdSw1b
• PdSw2a
• PdSw2b
• SW1 Button
Controller
Description
Destination
ProgDec Program Decrement—decrements current Program number.
ProgGoto Go to Program—selects Program.
SetupInc Multi Increment—increments current Multi number.
SetupDec Multi Decrement—increments current Multi number.
SetupGoto Go to Multi—selects Multi.
Start
Stop
Continue
TransUp Transpose Up (ST)
TransDown Transpose Down (ST)
Multi Edit Mode
The Zone-specific Parameters
8-13