Restore - Kurzweil Artis SE Musician's Manual

3. Follow the instructions specified on page 11-1 to enter System Mode. The Artis SE will
appear as a removable disk/drive on your computer.
4. Press the Param/Channel ▲ button once. The display shows
+
5. Press the
To select Update, press the
your computer. Once copied, "Safely Remove" or "Unmount" the removable disk/drive from
your computer.
+
6. Press the
message
7. Once you see a
main menu.

Restore

Whenever you update the Artis SE's software, a backup of the currently installed software is
made. This is in case of a need to revert back to the old software, such as if the new update
has problems or for troubleshooting.
NOTE: Only the previously installed version of the software is backed up. When you
perform a
back and forth between versions.
Unlike the Update operation, the Restore operation can be performed without a computer
connected to the Artis SE:
1. Follow the instructions specified on page 11-1 to enter System Mode.
2. Press the Param/Channel ▲ button once. The display shows
+
3. Press the
4. Press the Param/Channel ▲ button again. This display shows
+
5. Press the
6. Press the Exit button to cancel and return to the System Mode main menu.
button once. The display shows
+
button once. The display shows
. Copy the file to the Artis SE removable disk/drive on
button on the Artis SE. If the .KUF file is valid, the Artis SE will display the
. This will take a minute or two.
message press the Exit button to return to the System Mode
operation again, the current version is backed up. So, it's possible to go
button once. The display shows
button to restore the previous software version.
System Mode (Boot Loader)
Update Software
.
.
.
.
.
11-3