DCS RGV2-488 User Manual page 39

WHAT?
HOW?
HOW OFTEN?
OVEN PARTS
Oven door
gasket
1 Dampen a sponge with clean hot
2 Gently wipe off the soiling, but do
3 Press a dry towel gently on the
COOKTOP PARTS
1 Check that the burner is turned
Burner caps
and brass
2 Lift off the burner cap and brass
flame
spreaders
3 Wash them in hot soapy water,
●
4 Replace the flame spreader and
1 Check that the burner is turned
Ignitors
2 Clean the ignitor with a small brush
Burner grates 1 Wait until the grates have cooled
2 Carefully lift the grates off the
3 To remove stubborn stains, soak
4 Wash in a mixture of hot water and
●
CARE AND CLEANING
Avoid cleaning this part. If you need
to remove large food particles off it,
proceed as follows:
water.
not rub.
gasket to dry.
OFF and allow it to cool.
flame spreader.
rinse, and dry.
Use a stiff nylon brush or straight-
ended paper clip to clear the
notches of the flame spreader.
burner cap correctly. See 'Replacing
the burner parts'.
OFF.
(e.g. old toothbrush) or cotton swab
that has been dipped into rubbing
alcohol.
completely.
cooktop and place them on a
protected surface.
the grates in a mixture of clothes
washing detergent and water.
dishwashing liquid, then rinse and
allow to dry.
The grates are also dishwasher safe.
IMPORTANT!
Do not use any cleaning
●
agent on the gasket.
The gasket is essential
●
for a good seal. Take care
not to rub, displace, or
damage it.
Keep the notches of
●
the flame spreaders
clear. Soiling may clog
these and cause ignition
problems.
Before replacing the
●
burner parts, check that
they are dry. Wet burner
parts may result in an
irregular flame.
Before lighting a burner
●
you have reassembled,
check that all of its parts
are positioned correctly.
Incorrect assembly can
cause dangerous irregular
flames and ignition
problems.
The ignitors must be kept
clean and dry to work
correctly. Dirty
or wet ignitors could cause
constant clicking and
sparking, even if a flame is
present.
Take care, the grates are
●
heavy.
Make sure you place a
●
dish towel or other soft
cover on the surface
before putting a grate
on it.
37