Paper Is Not Cut Neatly - Canon imageprograf ipf755 User Manual

Paper is not cut neatly

The paper is bent or curled at the cut posi-
tion.
Paper rises by the ends of the cut position be-
fore it is cut.
You are using paper that cannot be cut with
the Cutter Unit.
Cut Speed is not configured correctly in the
Control Panel menu.
During cutting, printed documents fall out at
an angle.
Paper is not cut
In the printer driver, No or Print Cut Guideline is
specified in Auto Cut.
In the Control Panel menu, Cutting Mode is set to
Eject or Manual.
Depression on the leading edge is left
Keeping a roll in the printer for a long
time without printing on it may leave a
depression on the leading edge.
The size of clear film cannot be detected
The Platen is soiled with ink or other substances.
iPF755
Downloaded from ManualsPrinter.com Manuals
Cause
Cause
Cause
When printing quality is most important, we recommend setting Tri-
mEdge Reload to On or Automatic so that the paper edge is automatical-
ly cut before printing.
(See "Menu Structure.")
Cause
Corrective Action
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use
scissors or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
→P.727
In the Control Panel menu, set Cutting Mode to Eject. Hold docu-
ments after printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Corrective Action
Specify Yes in Auto Cut in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the pa-
per.
If the Cutting Mode is Manual, cut rolls with scissors or the
like.
Corrective Action
→P.727
Corrective Action
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
Troubleshooting > Problems Regarding Paper
→P.652
→P.652
→P.824
Paper is not cut neatly
>
12
849