Image Posting - Bosch AUTODOME IP 4000 HD Operation Manual

AUTODOME IP 4000 HD / AUTODOME
IP 5000 HD/IR
Streaming
Click the checkbox to activate multicast streaming mode for the relevant stream. An enabled
stream is indicated by a check mark.
Multicast packet TTL
You can enter a value to specify how long the multicast data packets are active on the
network. This value must be greater than one if multicast is to be run via a router.
10.6

Image Posting

You can save individual JPEG images on an FTP server at specific intervals. You can then
retrieve these images at a later date to reconstruct alarm events if required. In order to
configure image posting, and to save and retrieve JPEG images, you must create an Account in
which to save and access them. If you have not configured an account, the following error
message appears at the top of this page: "No configured account. Configure accounts." Click
the link to access the Accounts page.
Image size
Select the size of the images that you want to save:
–
–
–
–
–
File name
You can select how file names will be created for the individual images that are transmitted.
–
–
–
Posting interval
Enter the interval in seconds at which the images will be sent to an FTP server. Enter 0 (zero)
if you do not want any images to be sent.
Target
Select the target—the name of the account on the server—to which to save images.
When face recognition is available, selected images of the face can be sent to a target
account.
Enable
Click this checkbox to enable face detection.
File format
Select the file format in which to save images. Options are JPEG (default), YUV420, TIFF.
Timeout [s]
Enter the number of seconds after which image posting will time out. The default is 0 (no
timeout).
Maximum image width [px]
Enter a number for the maximum width, in pixels, for the saved images. For automatic width
selection, use value "0."
Bosch Security Systems
Small
Medium
Large
720p
1080p
Overwrite The same file name is always used and any existing file will be overwritten with
the current file.
Increment A number from 000 to 255 is added to the file name and automatically
incremented by 1. When it reaches 255 it starts again from 000.
Date/time suffix The date and time are automatically added to the file name. When
setting this parameter, ensure that the unit's date and time are always correctly set.
Example: the file snap011005_114530.jpg was stored on October 1, 2005 at 11:45 and
30 seconds.
Operation Manual
Network | en 51
2016.04 | 0.4 |