Configuration Prerequisites - Bosch AUTODOME IP 4000 HD Operation Manual

AUTODOME IP 4000 HD / AUTODOME
IP 5000 HD/IR
1

Configuration Prerequisites

To operate the camera in your network, you must configure the camera properly for your
network. You will need the following information:
–
–
–
–
Notice!
Ensure that the network parameters of your camera are available before you begin
configuration. Contact your local network administrator for a valid IP address, Subnet mask,
and Gateway IP address.
The following sections provide instructions about installing the software necessary to view
images over an IP connection, configuring the IP network settings, and accessing the camera
images from a Web browser.
The camera has a default IP address of 192.168.0.1. To change the IP address or any network
settings, you can use the Configuration Manager software or the built-in Web server.
Notice!
Contact your local network administrator for a valid IP address, Subnet Mask, and a Gateway
IP Address.
Using the Configuration Manager
Configuration Manager is an optional network utility provided on the Bosch Security Systems
Web site. Use the Configuration Manager Manual to make any configuration changes.
Notice!
Depending on the PC network security settings, the user may need to add the new IP address
to the browser's trusted sites list for the controls to operate.
Using the built-in Web Server
1.
2.
3.
4.
5.
Bosch Security Systems
Unit IP address: An identifier for the camera on a TCP/IP network.
Default: 192.168.0.1 (if your network does not have a DHCP server)
or
the first available IP address (if your network has a DHCP server)
Note: You will likely need to change the IP address of your camera so that it does not
conflict with another device on your network. Refer to the section Network > Network
Access for more information.
Subnet mask: A mask used to determine what subnet an IP address belongs to.
Default: 255.255.255.0
Gateway IP address: A node on a network that serves as an entrance to another network.
Default: 0.0.0.0
Port: An endpoint to a logical connection in TCP/IP and UDP networks. The port number
identifies the use of the port for use through a firewall connection.
Set the IP address on the network device to 192.168.0.10 to ensure that the network
device and the camera are on the same Subnet.
Launch your web browser (such as Microsoft Internet Explorer) and navigate to the
following URL: http://192.168.0.1. The web browser opens the Live page for the camera;
a security warning message appears.
Select the box Always Trust, and then click YES.
Click Configuration at the top right of the page.
Select Network. The menu expands.
Operation Manual
Configuration Prerequisites | en
2016.04 | 0.4 |
5