Alarm; Alarm Connections - Bosch AUTODOME IP 4000 HD Operation Manual

38 en | Alarm
8

Alarm

8.1

Alarm Connections

You can select how the camera responds to an alarm. In the event of an alarm, the unit can
automatically connect to a pre-defined IP address. You can enter up to ten IP addresses to
which the camera will connect in sequence in the event of an alarm, until a connection is
made.
Connect on alarm
Select On so that the camera automatically connects to a predefined IP address in the event
of an alarm.
By setting Follows input 1 the unit maintains the connection that has been automatically
established for as long as an alarm exists on alarm input 1.
Notice!
In the default setting, Stream 2 is transmitted for alarm connections. Bear this fact in mind
when assigning the profile (see Encoder Profile).
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote stations one after the other in the numbered sequence until a connection
is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Destination password
If the remote station is password protected, enter the password here.
In this page, you can save a maximum of ten destination IP addresses and hence up to ten
passwords for connecting to remote stations. If connections to more than ten remote stations
are to be possible, for example when initiating connections via higher-ranking systems such as
VIDOS or Bosch Video Management System, you can store a general password here. The
camera can use this general password to connect to all remote stations protected with the
same password. In this case, proceed as follows:
1.
2.
3.
4.
Notice!
If you enter the destination IP address 0.0.0.0 for destination 10, this address will no longer
be used for the tenth attempt at automatic connection in the event of an alarm. The
parameter is then used only to save the general password.
Video transmission
If the unit is operated behind a firewall, select TCP (HTTP port) as the transfer protocol. For
use in a local network, select UDP.
2016.04 | 0.4 |
Select 10 from the Number of destination IP address list field.
Enter the address 0.0.0.0 in the Destination IP address field.
Enter your chosen password in the Destination password field.
Define this password as the user password for all remote stations to which a connection
is to be possible.
Operation Manual
AUTODOME IP 4000 HD / AUTODOME
IP 5000 HD/IR
Bosch Security Systems