Bosch CCS 1000 D Operation Manual page 47

Digital Discussion System
–
–
Notice!
Ensure that the Bosch Onvif Camera has firmware 5.80 or higher.
Network and general settings
Click the Network and general settings button to open the network and general settings
page. Here the network and general settings are displayed and can be set:
Click the Change network settings button to enter/change the network settings:
–
–
–
Notice!
When the system is reset to the factory defaults, the latest version of the software that the
system was upgraded to will be maintained.
Bosch Security Systems B.V.
Example:
– Correct IP address: 192.168.10.111
– Incorrect IP address: 192.168.010.111
Recycle bin: Click the recycle bin icon to remove the selected camera. Note: Only a
disconnected camera can be removed.
Camera settings overview: Here an overview of all connected cameras is listed, including:
– Camera name: The name of the camera.
– Serial number: Click the blue hyperlink to view the camera configuration web page.
This is only possible if a cable is used to connect your PC configuration device to the
Control Unit.
– Version: The software version of the camera.
– Type: The type of camera.
– Input: The video switcher input that the camera is connected to. A total of 6 cameras
can be connected to the CCS 1000 D Digital Discussion System.
Network settings:
– Hostname: The default hostname is CCS1000D
Note: When changing the hostname or (de)activating the fixed IP address in the web
browser interface (see below), the laptop/PC might lose the connection with the
Control Unit. If this happens, close and then re-open the web browser interface.
Wired:
– Fixed IP: Select this checkbox if you want to use a fixed IP address. The fields below
change from grey to white to indicate that they are activated.
– IP address: Enter a valid IP address.
– Subnet mask: Enter a valid subnet mask.
– Default gateway: Enter a valid default gateway.
General settings:
– Automatically shutdown the system when not used (energy saving mode): When
selected, the control unit is automatically shut down when it is not used for two
hours. The 'waiting list' and 'speakers list' are automatically saved, and will be
available when the system is powered on.
Note: This feature does not apply to the voice activation mode.
– Factory default: Click the factory default button to reset all system settings and
values to the factory defaults.
Operation manual
Configuration | en 47
2016.05 | V2.0 |