Oki C5400 User Manual page 61

Note: Factory default settings are shown in
Item
FRAME TYPE
IP ADDRESS
SET
IP ADDRESS
SUBNET MASK xxx.xxx.xxx.xxx
GATEWAY
ADDRESS
INITIALIZE
NIC?
WEB/IPP
Network Menu (continued)
Settings
AUTO
802.2
802.3
ETHERNET II
SNAP
AUTO
MANUAL
xxx.xxx.xxx.xxx
Default =
192.168.100.100
Default =
255.255.255.000
xxx.xxx.xxx.xxx
Default =
192.168.100.254
[EXECUTE]
ENABLE
DISABLE
Menu Functions • 59
bold
Explanation
Selects the Ethernet MAC layer frame
type.
Change this to Manual to specify the IP
address through the front panel.(see
next entry) Required for non-DHCP
networks.
Current assigned IP address. To
change:
• Press ENTER.
• Use +/– keys to increment first octet.
• Press ENTER to move on to the next
octet.
• Use +/– keys to increment second
octet.
• Press ENTER to move on to the next
octet.
• Use +/– keys to increment third octet.
• Press ENTER to move on to the last
octet.
• Use +/– keys to increment 1st octet.
• Press ENTER to register the new
address.
Current assigned subnet mask. To
change, proceed as above.
Current assigned gateway address. To
change, proceed as above.
Initializes the network card.
Enables or disables Web config. facility
and Internet Printing Protocol.
This item will not appear in the menu if
TCP/IP is set to DISABLE.
.