Related Manuals for Maktec MT241
Summary of Contents for Maktec MT241
- Page 1 INSTRUCTION MANUAL Portable Cut-Off MT241 012155 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model MT241 Wheel diameter 355 mm Hole diameter 25.4 mm No load speed (min 3,800 Dimensions (L x W x H) 500 mm x 280 mm x 620 mm Net weight 15.7 kg Safety class • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. -
Page 3: Additional Safety Rules For Tool
Dress properly. conditions that may affect its operation. A guard or Do not wear loose clothing or jewellery, they can other part that is damaged should be properly be caught in moving parts. Rubber gloves and repaired or replaced by an authorized service non-skid footwear recommended... -
Page 4: Installation
14. Use the cutting edge of the wheel only. Never For tool with lock button use side surface. To start the tool, simply pull the switch trigger. Release 15. If the wheel stops during the operation, makes the switch trigger to stop. an odd noise or begins to vibrate, switch off For continuous operation, pull the switch trigger and then the tool immediately. - Page 5 The original spacing or interval between the vise and the ASSEMBLY guide plate is 0 - 170 mm. If your work requires wider spacing or interval, proceed as follows to change the spacing or interval. CAUTION: Remove the two hex bolts which secure the guide plate. Always be sure that the tool is switched off and •...
-
Page 6: Securing Workpiece
If you use a spacer block which is slightly narrower than Securing workpiece the workpiece as shown in the figure, you can also utilize the wheel economically when worn down the wheel. 1. Vise plate 2. Vise nut 1. Diameter of 3. -
Page 7: Replacing Carbon Brushes
Replacing carbon brushes Workpiece shape 1. Limit mark Cutting angle 115 mm 119 mm 001145 Remove and check the carbon brushes regularly. 115 mm 106 mm Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same Workpiece time. - Page 8 Makita Corporation www.makita.com 885055A4...