Related Manuals for Maktec MT583
Summary of Contents for Maktec MT583
-
Page 1: Circular Saw
INSTRUCTION MANUAL Circular Saw MT583 013541 DOUBLE INSULATION IMPORTANT: Read Before Using. -
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model MT583 Blade diameter 185 mm at 90° 66 mm Max. cutting depth at 45° 44 mm No load speed (min 4,900 Overall length 284 mm Net weight 3.7 kg Safety class • Due to our continuing program of research and development, the specifications herein are subject to change without notice. -
Page 3: Circular Saw Safety Warnings
Do not abuse the cord. Never use the cord for Power tool use and care carrying, pulling or unplugging the power tool. 18. Do not force the power tool. Use the correct Keep cord away from heat, oil, sharp edges or power tool for your application. - Page 4 Do not reach underneath the workpiece. The into the top surface of the wood causing the blade guard cannot protect you from the blade below to climb out of the kerf and jump back toward the the workpiece. operator. Adjust the cutting depth to the thickness of Kickback is the result of saw misuse and/or incorrect the workpiece.
- Page 5 lower guard with the retracting handle and make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut. 19. Check the operation of the lower guard spring. If the guard and the spring are not operating properly, they must be serviced before use.
- Page 6 32. Keep blade sharp and clean. Gum and wood pitch hardened on blades slows saw and Fig. 1 increases potential for kickback. Keep blade clean by first removing it from tool, then cleaning it with gum and pitch remover, hot water or kerosene.
-
Page 7: Functional Description
Sighting FUNCTIONAL DESCRIPTION 1. Base plate CAUTION: Always be sure that the tool is switched off and • unplugged before adjusting or checking function on the tool. Adjusting depth of cut CAUTION: 004029 After adjusting the depth of cut, always tighten the •... - Page 8 Mount the inner flange with its recessed side facing ASSEMBLY outward onto the mounting shaft and then place saw blade, outer flange and hex bolt. BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE CAUTION: SECURELY. Always be sure that the tool is switched off and •...
-
Page 9: Operation
OPERATION MAINTENANCE CAUTION: CAUTION: Be sure to move the tool forward in a straight line Always be sure that the tool is switched off and • • gently. Forcing or twisting the tool will result in unplugged before attempting to perform inspection overheating the motor and dangerous kickback, or maintenance. - Page 12 Makita Corporation www.makita.com 885190A8...