ATTO Technology Diamond Storage Array S-Class Installation And Operating Manual page 8

6.4 RAID Level 5 .........................................................................59
6.5 RAID Level 10 .......................................................................63
6.6 Rebuilding RAID Configurations ........................................65
6.7 RAID Interleave Parameters ................................................67
7.0 Hardware Maintenance ...................................................................69
7.1 Hot Swap Operating Instructions .......................................71
7.2 Optional Hot Spare Sled ......................................................73
8.0 Copying Drives ................................................................................75
9.0 Updating Firmware .........................................................................77
Configuring a fully-populated array
To set up one RAID Level 5 group with one Hot Spare sled
To set up two RAID Level 5 groups with two Hot Spare sleds
Configuring a partially-populated array
To set up one RAID Level 5 group with one Hot Spare sled
Removing RAID groups
To set up RAID Level 10 groups
To remove RAID groups
Hot Spare sleds
To set up RAID Level 10 with Hot Spare sleds
To reset LUN status
To synchronize mirrored drives automatically
Rebuild priority
To synchronize mirrored drives manually
To change the RAID Interleave parameter
To remove a management card
To remove a disk drive sled (Exhibit 7-2)
To remove a Host Interface Card
To remove the power supply (Exhibit 7-4),
To remove a blower assembly (Exhibit 7-4),
Disk drives
Power supplies
Blower assemblies
To replace a blower assembly
To set up RAID Level 1 with Hot Spare sleds
To set up RAID Level 10 with Hot Spare sleds
To set up one RAID Level 5 group with one Hot Spare sled
To set up two RAID Level 5 groups with Hot Spare sleds
Procedure
Updating firmware using the RS-232 serial port
To update firmware
Updating firmware using the optional Ethernet card