Table Of Contents - ATTO Technology Diamond Storage Array S-Class Installation And Operating Manual

Preface
1.0 Diamond Storage Array Product Overview ..................................1
2.0 Diamond Storage Array Technical Overview ...............................3
3.0 Installation Instructions .................................................................5
3.1 Components .........................................................................7
3.2.1 Connecting a Fibre Channel Array .......................11
3.2.2 Connecting a SCSI Array .......................................13
4.0 Determining Drive and Sled Designations ...................................15
5.0 Accessing the Array .......................................................................17
Contents
Diamond Storage Array features
Fibre Channel model
SCSI model
ADXT Powers ATA to New Levels
Three major steps are required to set up the Diamond Storage Array
Step 1: physical setup
Step 2a: set up the Ethernet connection
Step 2b: connect to Ethernet
If the Diamond Storage Array is attached to a DHCP server
If the Diamond Storage Array is not attached to a DHCP server and you wish to change the
defaults
Step 3: set up RAID configuration
Floor model
Rack mount
Floor model
Rack mount
General instructions
Autoconfiguration
Manual configuration
To connect a SCSI array
Numbering conventions
Physical numbering
Logical numbering
Examples
Unique serial number for each LUN
Command Line Interface
ATTO ExpressNAV
In-band SCSI over Fibre Channel
RS-232 port
Ethernet port
SNMP