Serial Port Configuration Commands; Serialportbaudrate; Serialportecho; Serialporthandshake - ATTO Technology Diamond Storage Array S-Class Installation And Operating Manual

5.5.5 Serial Port Configuration Commands

The serial port configuration may be customized by using the following commands.

SerialPortBaudRate

Sets the baud rate the Diamond Storage Array will use for
its terminal interface. Choices are 2400, 9600, 19200,
38400, 57600, 10.
Default: 115200
Set syntax: set SerialPortBaudRate
[2400|9600|19200|3840057600|115200]
Requires a SaveConfiguration command
Get syntax: get SerialPortBaudRate

SerialPortEcho

Controls whether the Diamond Storage Array echoes
characters on its RS-232 port. Local ASCII terminal (or
terminal emulator) echo settings should be set to disabled
while in serialportecho enabled
Default: disabled
Set syntax: set SerialPortEcho [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get SerialPortEcho
39
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual

SerialPortHandshake

Describes which handshaking method the Diamond
Storage Array will use for its terminal interface
(hardware, Xon/Xoff or none)
Default: none
Set syntax: set SerialPortHandshake [hard| Xon| none]
Requires a SaveConfiguration command
Get syntax: get SerialPortHandshake
SerialPortStopBits
Configures/reports the number of stop bits per character
for the Diamond Storage Array RS -232 serial port. The
number of data bits per character is fixed at 8 with no
parity. Choices are 1 or 2.
Default: 1
Set syntax: set SerialPortStopBits [1 | 2]
Requires a SaveConfiguration command
Get syntax: get SerialPortStopBits