Table of Contents
Advertisement
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on a specific topics. Each page can be reached through the menu on the left hand side of each
page.
Status
Contains general array information.
• Unit Information including Vendor ID, Product
ID, Firmware Revision and Serial Number
• Environmental Information
• World Wide Identifiers including Node Names
and Port Names
• Host Interface Card Status
• Fan Status
• Power Supply Status
• Storage Status including ATA Disk Errors and
Logical Unit Conflicts
Ethernet
Configures the Ethernet port.
• IP Address
• IP Gateway
• IP Subnet Mask
• Ethernet Speed
• Use DHCP
Refer to
Ethernet Access: Telnet and SNMP Protocols
on page 23 and
Ethernet Commands
details.
SNMP
Remote system monitoring is available using
Simple Network Management Protocol (SNMP).
• Updates
• Traps
• Trap Recipient IP Addresses
Refer to
Ethernet Commands
Access: Telnet and SNMP Protocols
details on each parameter.
Serial Port
Contains the necessary information to configure
the serial port including baud rate and echo.
Refer to
Serial Port Access
Configuration Commands
information on each parameter.
Fibre Channel
Contains parameters and information to manage
the Fibre Channel port.
27
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
5.4.1 ExpressNAV Pages
on page 35 for
on page 35 and
Ethernet
on page 23 for
on page 21 and
Serial Port
on page 39 for more
• Data rate
• Full duplex mode
• Connection mode
Refer to
Connecting a Fibre Channel Array
and
Fibre Channel Configuration Commands
37 for more information.
Storage Management
Shows information about the drives and their
status. Information includes
• Sled Number
• Capacity of each sled
• Number of errors
• Configuration type (JBOD, RAID5, etc.)
• Virtual ID
You may place sleds on or off line by selecting or
de-selecting a check box.
Refer to
Determining Drive and Sled Designations
page 15 and
Drive Configuration Commands
45 for more information.
Once you open this page, several other
configuration pages are available on the menu on
the left hand side of the page.
RAID
Contains the necessary information and
parameters to configure RAID groups.
Information provided includes
• Type of configuration (RAID5, JBOD, etc.)
• Virtual Disk ID
• State of sleds
• Capacity of sleds
• Interleave values
You may change the configuration of these
parameters
• Configuration Type (JBOD, RAID5)
• Number of Groups (when applicable)
• Interleave
• Striping method (sled or drive)
• Rebuild priority
on page 11
on page
on
on page
Advertisement
Table of Contents
