General Use Commands; Firmwarerestart; Help; Restoreconfiguration - ATTO Technology Diamond Storage Array S-Class Installation And Operating Manual

The following commands, listed alphabetically, describe or perform general functions.

FirmwareRestart

Causes a warm restart of the Diamond Storage Array.
Immediate: FirmwareRestart

Help

Displays a list of available commands. Type help
followed by a command name to display detailed
command-specific information.
Immediate: Help [Command Name]

RestoreConfiguration

Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option will undo any changes made since the
last save.
Immediate: RestoreConfiguration [Default|Saved]

SaveConfiguration

If the restart option is selected, the Diamond will cycle its
power. The norestart option will save changes without
restarting. Please note: certain modifications require a
SaveConfiguration command and a system restart. If
required, the return Ready. * will be displayed after the
33
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual

5.5.2 General Use Commands

return for the modification. You may make several
changes through commands and SaveConfiguration
before implementing a restart, but once you have
restarted the Diamond, all the command changes created
before the restart and saved will be implemented. Restart
or no Restart parameter is optional
Immediate: SaveConfiguration <Restart| NoRestart>

SystemSN

Stores the Diamond Storage Array serial number. The
serial number may be one to 16 characters.
Set syntax: set SystemSN [n]
Get syntax: get SystemSN
Requires a SaveConfiguration command

VerboseMode

Specifies the detail of verbal feedback for the Command
Line Interface. Disabling this option removes parameter
names from 'get' commands and removes descriptions
from 'help' commands.
Default: enabled (returns have parameter information)
Set syntax: set VerboseMode [enabled | disabled]
Get syntax: get VerboseMode