Oki MC160N User Manual page 129

3
Specify the desired scan settings.
For details on specifying the destination of the data, refer to "Specify-
ing the Data Location" on page 130 and "Specifying the Destination
Address (Scan to E-mail/FTP/SMB)" on page 132.
For details on selecting the data format, refer to "Selecting the Data
Format" on page 146.
For details on selecting the scan quality setting, refer to "Selecting the
Scan Quality Setting" on page 147.
For details on setting the scan size, refer to "Setting the Scan Size" on
page 148.
For details on setting the color of the scan data, refer to "Setting the
Scan Color" on page 148.
For details on specifying the subject when sending data, refer to
"Specifying the Subject" on page 148.
4
To scan color scans, press the Start-Color key. To scan monochrome scans,
press the Start-Mono key.
If the document was loaded in the ADF, scanning begins, and then the data is
sent to the specified location. If the document was placed on the original
glass, continue with step 5.
Scanning with the Scan to PC operation is possible only if this
machine is connected to a computer using a USB cable.
5
When NEXT PAGE? appears in the message window, place the second doc-
ument page on the original glass, and then press the Enter key.
When scanning with the Scan to PC operation, a multi-page document
cannot be scanned with the original glass. To scan a multi-page docu-
ment, load the document into the ADF.
6
Press the up arrow or down arrow key to select the size of the document
positioned in step 5, and then press the Enter key.
7
After all document pages have been scanned, press the Start key.
The scanned document is sent to the specified location.
If the Stop/Reset key is pressed while scanning, JOB CANCEL
appears. To continue scanning, select NO. To stop scanning, select
YES.
To cancel a job where scanning was finished and the data is queued
to be sent, refer to "Deleting a Queued Transmission Job" on
page 149.
129 Using the Scanner