Status: Port Details - ZyXEL Communications MES3500 series User Manual

Table 9 Status (continued)
LABEL
Link
State
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Clear Counter

7.2.1 Status: Port Details

Click a number in the Port column in the Status screen to display individual port statistics. Use this
screen to check status and detailed performance data about an individual port on the Switch.
Chapter 7 System Status and Port Statistics
DESCRIPTION
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or 1000M for
1000Mbps) and the duplex (F for full duplex or H for half). It also shows the cable type
(Copper or Fiber) for the combo ports.
This field displays Down if the port is not connected to any device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port (see
Section 13.1 on page 115
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays
STOP.
This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on
the port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has been
up.
Enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.
MES3500 Series User's Guide
for more information).
74