Wall Mounting - ZyXEL Communications MES3500 series User Manual

Figure 6 Mounting the Switch on a Rack
Using a #2 Philips screwdriver, install the M5 flat head screws through the mounting bracket holes
2
into the rack.
Repeat steps
3

2.4 Wall Mounting

See Table 1 on page 18
your Switch to a wall.
You may need screw anchors if mounting on a concrete or brick wall.
Table 2 Wall Mounting Information
Distance between holes
Self-tapping screws (Diameter: 3 mm)
Screw anchors (optional)
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
Chapter 2 Hardware Installation and Connection
1 and 2 to attach the second mounting bracket on the other side of the rack.
for the Switch models that can be wall-mounted. Do the following to attach
MES3500 Series User's Guide
198 mm
Two
Two
24