Dhcpv4 Global Relay Port Configure - ZyXEL Communications MES3500 series User Manual

Figure 175 IP Application > DHCP > DHCPv4 > Global
The following table describes the labels in this screen.
Table 129 IP Application > DHCP > DHCPv4 > Global
LABEL
Active
Remote DHCP
Server 1 .. 3
Option 82
Profile
Apply
Cancel

37.4.4 DHCPv4 Global Relay Port Configure

Use this screen to apply a different DHCP option 82 profile to certain ports on the Switch. To open
this screen, click IP Application > DHCP > DHCPv4 > Global > Port.
Figure 176 IP Application > DHCP > DHCPv4 > Global > Port
Chapter 37 DHCP
DESCRIPTION
Select this check box to enable DHCP relay.
Enter the IP address of a DHCP server in dotted decimal notation.
Select a pre-defined DHCPv4 option 82 profile that the Switch applies to all ports. The Switch
adds the Circuit ID sub-option and/or Remote ID sub-option specified in the profile to DHCP
requests that it relays to a DHCP server.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES3500 Series User's Guide
280