Tacacs+ Server Setup - ZyXEL Communications MES3500 series User Manual

Table 79 Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL
Delete
Apply
Cancel
Accounting
Server
Timeout
Index
IP Address
UDP Port
Shared Secret
Delete
Apply
Cancel

26.2.2 TACACS+ Server Setup

Use this screen to configure your TACACS+ server settings. See
more information on TACACS+ servers. Click on the TACACS+ Server Setup link in the
Authentication and Accounting screen to view the screen as shown.
Chapter 26 AAA
DESCRIPTION
Check this box if you want to remove an existing RADIUS server entry from the Switch. This
entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to configure your RADIUS accounting server settings.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the RADIUS accounting server.
This is a read-only number representing a RADIUS accounting server entry.
Enter the IP address of an external RADIUS accounting server in dotted decimal notation.
The default port of a RADIUS accounting server for accounting is 1813. You need not change
this value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between the
external RADIUS accounting server and the Switch. This key is not sent over the network.
This key must be the same on the external RADIUS accounting server and the Switch.
Note that as you type a password, the screen displays an asterisk (*) for each character you
type.
Check this box if you want to remove an existing RADIUS accounting server entry from the
Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES3500 Series User's Guide
206
Section 26.1.2 on page 204 for