Section 2 - Installation
To mount your camera on a wall or ceiling, please follow the steps below.
It is suggested that you configure the camera before mounting.
Place the mounting bracket where you want to position the camera and use a
pencil to mark the holes.
Use appropriate tools to drill two holes the same diameter as the plastic anchors.
After drilling the holes, insert the plastic anchors to support the screws.
If desired, the power and Ethernet cables can be concealed behind the
mounting bracket. Run the cables through the back of the mounting bracket,
securing them with the built-in guides. Be sure to leave enough cable length
protruding from the top to allow connection to the camera.
D-Link DCS-5025L User Manual
Mounting the Camera
1
2
3
23