D-Link DCS-5025L User Manual page 44

Section 3 - Configuration
Step 4 - Enter the destination e-mail address in Receiver
E-mail Address.
Step 5 - Enter the user name required to access the SMTP
server.
Step 6 - Enter the password required to access the SMTP
server.
Step 7 - Select SSL-TLS and then click Save Settings.
Step 8 - Click the Test button to send a test e-mail to the
account listed above.
Note: You can also use STARTTLS, which will use SMTP server
port number 587.
Note: If you want to use a Yahoo SMTP server, the SMTP server
address will be different between each registered region, and
only SMTP port 465 is supported for SSL-TLS.
Enable the Enabling this will allow snapshots to be e-mailed to you in
e-mailing different ways:
of images
to an e-mail • Choosing Always will e-mail snapshots continuously
account: based on the E-mail Interval specified.
• Choosing Schedule will allow you to schedule when to
start and stop the e-mailing of snapshots.
• Select Motion/Sound Detection if you would like the
camera to e-mail images only when motion or sound is
detected. You can choose whether to e-mail a snapshot
immediately, or e-mail 6 snapshots together, with 3
frames before and after motion/sound was detected. You
can also set the Frame interval time to specify how far
apart the snapshots should be.
D-Link DCS-5025L User Manual 44 44