Mounting The Camera - D-Link DCS-5020L Quick Installation Manual

Mounting the Camera

To mount your camera on a wall or ceiling, please follow the steps below.
It is suggested that you configure the camera before mounting.
Place the mounting bracket where you want to
position the camera and use a pencil to mark the
holes.
Use appropriate tools to drill two holes the same
diameter as the plastic anchors. After drilling the holes,
insert the plastic anchors to support the screws.
If desired, the power and Ethernet cables can be
concealed behind the mounting bracket. Run the
cables through the back of the mounting bracket,
securing them with the built-in guides. Be sure to
leave enough cable length protruding from the top
to allow connection to the camera.
Fasten the mounting bracket to the wall using the
screws provided.
Do not overtighten the screws as this may crack the mounting bracket.
2
6
1
3
4