Updating Firmware; Preliminary Steps; Using Atto Expressnav; Using Ftp Over Gbe - ATTO Technology iPBridge 2500C Installation And Operation Manual

Several processors control the flow of data in the ATTO iPBridge. The firmware to control these
processors can easily be upgraded in the field using the ATTO ExpressNAV interface or the PUT
command from an FTP connection. The ATTO ExpressNAV method is preferred.

Preliminary steps

1 The iPBridge firmware is distributed as a
compressed .zip file and can be obtained from
the ATTO Technology, Inc. web site at
www.attotech.com
your iPBridge.
2 Uncompress the .zip file into an image file
(.ima). Note the filename.
CAUTION CAUTION
Before beginning this procedure, ensure
that all I/O to the iPBridge has stopped.
During this procedure, do not interrupt the
flash process.
Do not power down the host or the
iPBridge until the display returns the
Ready prompt.
Interrupting the flash process will make
your iPBridge inoperable and you will have
to return it to ATTO Technology for repair.
Note
The recommended management tool for the
iPBridge is ATTO ExpressNAV.
25
ATTO Technology Inc. iPBridge Installation and Operation Manual

4 Updating firmware

or from the CD included with

Using ATTO ExpressNAV

1 Connect to ExpressNAV (refer to
ExpressNAV interface
the Firmware page.
2 Click Browse and locate the firmware you
unzipped in the preliminary steps.
3 Click Upload and wait until a success message
is displayed.
4 Click the Restart link.
5 Click on Restart.

Using FTP over GbE

1 Establish an FTP link to the bridge that is to be
flashed.
2 Use the PUT command to download the
firmware you unzipped in the preliminary steps.
For example
c:\bridge_firmware\I25i0300.ima
3 Once the download is complete, cycle power on
the iPBridge or use the FirmwareRestart CLI
command.
ATTO
on page 21) and click on