Configuring The Ipbridge; Microsoft Iscsi Initiator Changes - ATTO Technology iPBridge 2500C Installation And Operation Manual

Set up your iPBridge by first getting an IP address, then use ATTO ExpressNAV to map devices. Default
values are appropriate for most configurations, but may be modified for your needs using ATTO
ExpressNAV.
Configuration of the ATTO iPBridge, also known
as iPBridge Services, is available through the
ATTO ExpressNAV, a browser-based interface, or
the Command Line Interface (CLI).
ATTO iPBridge Services configures and tunes the
iPBridge for many different environments and
applications, updates the firmware, configures the
addresses of the connected devices, monitors
status and reports on hardware.
To use the iPBridge, you must
1 Know the IP address for the iPBridge. (Refer to
Getting an IP address
2 Map devices so that the iPBridge can access
the devices in your network. (Refer to
devices: NDMP on page 13 and
devices: iSCSI on page 15).
Additionally, it is best practice to change the
default user name and password and to set the
Real Time Clock. Refer to
configurations on page 19
9
ATTO Technology Inc. iPBridge Installation and Operation Manual

2 Configuring the iPBridge

on page 10).
Mapping
Mapping
Additional
Any changes must be saved and will not take
effect until the iPBridge is restarted.
Note
The recommended management tool for the
iPBridge is ATTO ExpressNAV. For details on
the interface, refer to
interface on page 21.

Microsoft iSCSI Initiator changes

Installing the file MSiSCSI_Adj.reg, found on
the ATTO iPBridge installation CD, makes
several Windows operating system registry
changes to optimize the ATTO iPBridge
performance when using the Microsoft iSCSI
Initiator.
1 Install Microsoft iSCSI Initiator.
2 Double click on the file MSiSCSI_Adj.reg
found on the installation CD.
The resident Windows operating system is
updated to use optimal settings.
ATTO ExpressNAV