Download Print this page

Hitachi RB 14DSL Handling Instructions Manual page 8

Cordless blower
Hide thumbs

Advertisement

English
(2) BSL1830: RB18DSL
2. Charger (UC18YRSL)
Charging voltage: 14.4 V 18 V
3. Dust bag
Optional accessories are subject to change without
notice.
APPLICATIONS
Cleaning facilities and equipment in lumbermills,
cigarette-making plants, spinning mills, etc.
Cleaning devices and equipment in repair shops.
Blowing operation.
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch
(2 pcs.) to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
For rechargeable batteries, please charge in according
to the handling instructions of the charger which you are
using. (Fig. 3, 4)
7
PRIOR TO OPERATION
1. Setting up and checking the work environment
Check if the work environment is suitable by
following the precautions.
MOUNTING AND DISMOUNTING THE NOZZLE
AND DUST BAG
1. Mounting the NozzIe
Insert the pin located outside the nozzle into the notch
provided on the blast port, and fully turn the nozzle in
the direction indicated by the arrow in Fig. 5.
To dismount the nozzle.,folIow the above procedures
in reverse.
2. When using the Cordless Blower for dust collection
(1) Mounting the Dust Bag
Mount the dust bag on the blast port, following
the same procedure described above for mounting
of the nozzle (Fig. 6).
(2) Mounting the nozzle
Insert the pin located on the outside of the nozzle
into the notch provided on the suction port, and
fully turn the nozzle in the direction indicated by
the arrow in Fig. 7.
HOW TO USE THE CORDLESS BLOWER
1. Switch operation
When the trigger switch is depressed, the tool
rotates. When the trigger is released, the tool stops.
2. An excessively large volume of dust in the dust bag
will reduce the dust collecting efficiency of the
cordless blower. Frequently empty the dust bag to
ensure maximum dust collecting efficiency.
MAINTENANCE AND INSPECTION
1. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so could result in serious hazard.
2. Maintenance of the motor
The motor unit winding is the very "heart" of the
power tool.
Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
3. Cleaning on the outside
When the coldless blower is stained, wipe with a soft
dry cloth or a cloth moistened with soapy water.
Do not use chloric solvents, gasoline or paint thinner,
for they melt plastics.
4. Storage
Store the coldless blower in a place in which the
temperature is less than 40°C and out of reach of children.
5. Service parts list
CAUTION
Repair, modification and inspection of Hitachi Power
Tools must be carried out by a Hitachi Authorized
Service Center.
This Parts List will be helpful if presented with the
tool to the Hitachi Authorized Service Center when
requesting repair or other maintenance.

Advertisement

loading

  Also See for Hitachi RB 14DSL

This manual is also suitable for:

Rb 18dsl