Status Lamp - Toshiba B-FV4D SERIES Owner's Manual

4. TROUBLESHOOTING
Symptom
Labels are not correctly
separated from the backing
paper. (When the optional
Peel-off unit is fitted.)
The media is not cut
cleanly. (When the optional
cutter unit is fitted.)
The Wireless LAN
communication error
occurs immediately after
turning on the printer.

4.2 Status Lamp

LED 1 LED 2
Green
F
Green
S
Green
Red
Orange
Red Green
Orange
Orange
Green
Red
Red
Red
Green
Red
Orange
Unlit
Flashing speed of the LED
Symbol
S Flashing slowly
M Flashing at medium speed
F Flashing fast
Cause
TOSHIBA TEC
CORPORATION approved media
is not used.
The labels have been loaded
incorrectly.
The cuter blade has reached the
end of its useful life.
It takes approx. 10 seconds to
enable the Wireless LAN
communication after the Status
Lamp shows a stand-by state.
Unlit Stand-by
Communicating with a host
Unlit
Printing is temporarily stopped
Unlit
(paused.)
The print head temperature
exceeded the upper limit.
F
A communication error
occurred. (Only when the RS-
232C is used.)
The media has ended.
Red
A paper jam occurred.
An issue or feed was
M
attempted with the print block
opened.
A paper jam occurred in the
F
cutter unit. (Only when the
cutter unit is fitted.)
The print head is broken.
M
The power is off.
Unlit The print head block is open if
the printer power is on.
Status
Replace the media with an approved one.
Load the label correctly. ( Section 2.7)
Turn off the printer and contact the nearest
TOSHIBA TEC CORPORATION
representative to ask for the replacement of the
cutter unit.
Turn on the printer, and wait more than 10
seconds after the Status Lamp shows a stand-by
state, then start the communication.
Cause
Normal
Normal
Press the [FEED] Button. Printing is resumed.
Stop printing and allow the print head to cool
until LED 1 lights in green. If LED 1 does not
light in green or this problem occurs frequently,
contact the nearest TOSHIBA TEC
CORPORATION representative.
Press the [FEED] Button to restart the printer or
Turn off the power and then back on. If this
problem frequently occurs, turn off the printer
and contact the nearest TOSHIBA TEC
CORPORATION representative.
Load a new media roll, then press the [FEED]
Button. （ Section 2.7）
Remove the jammed media, then reload the
media correctly and press the [FEED] Button.
（ Section 4.3）
Close the print block correctly, then press the
[FEED] button. Printing will resume.
Remove the jammed media, then reload the
media correctly and press the [FEED] Button.
( Section 4.3）
Turn off the power switch and contact the
nearest TOSHIBA TEC CORPORATION
representative.
Turn the power on.
Close the print block correctly.
Flashing interval
2.0 sec.
1.0 sec.
0.5 sec.
E4-2
ENGLISH VERSION EO1-33097
4.2 Status Lamp
Solutions
Solutions