Toshiba B-FV4D SERIES Owner's Manual page 23

2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
NOTES:
1. The sensor type used in the last
print job is selected by default.
To change the sensor type, refer
to Section 2.8.1 Media Sensor
Calibration.
2. The Feed Gap Sensor is
positioned 6.35 mm right from
the media centre.
Feed Gap Sensor
6.35mm
3. The Black Mark Sensor is
movable over the range of the
media width.
Black Mark Sensor is movable
in the full range.
NOTE:
Be careful not to squeeze the
media with the Media Guides.
Doing so bends the media,
which can cause a paper jam or
feed failure.
4. Check and adjust the media sensor position and select the sensor type
to be used. (Refer to Section 2.8.1.)
This printer has a Black Mark Sensor which can detect black marks
printed on the reverse side of the media, and a Feed Gap Sensor which
detects inter-label gaps. As the Feed Gap Sensor position is fixed, it is not
necessary to adjust it. When using the Black Mark Sensor, align it with
the centre of the black mark on the media. Failure to do this will disable
the detection of printed black marks, resulting in an error.
E2-10
ENGLISH VERSION EO1-33097
2.7 Loading the Media
Black Mark Sensor