Toshiba B-FV4D SERIES Owner's Manual page 26

2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
WARNING!
HAZARDOUS MOVING PARTS
KEEP FINGERS AND OTHER
BODY PARTS AWAY
The cutter is sharp, so care must
be taken not to injure yourself
when handling the cutter.
CAUTION!
1. Be sure to cut only the backing
paper of the label. Cutting
labels will cause glue to stick to
the cutter blades which may
affect the cutter quality and
shorten the cutter life.
2. Use of tag paper which
thickness exceeds the
maximum specified value may
affect the cutter life.
NOTE:
When placing fanfold paper
stock at the rear of the printer,
care should be taken of the
following points.
1. Face the print surface up.
2. The fanfold paper stock is
parallel to the fanfold paper
slot.
3. The interface and power
cables do not interfere with
the feeding of the fanfold
paper.
Cut mode (Option):
When a Cutter is fitted, the media can be automatically cut. When
loading the media as described on the previous pages, insert the leading
edge of the media through the Media Outlet of the Cutter Cover while
pulling the media through the printer.
Cutter Cover
Media Outlet
How to Load Fanfold Paper Stock
1. Place the fanfold paper stock at the rear of the printer, insert the
leading edge of the paper into the Fanfold Paper Slot.
Fanfold Paper Slot
Refer to the previous pages to feed the fanfold paper through the
2.
printer until it extends past the media outlet.
E2-13
ENGLISH VERSION EO1-33097
2.7 Loading the Media
Fanfold Paper Stock