Makita EH5000W Technical Information page 3

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Engine section
DISASSEMBLING
(1) Disconnect Bullet terminal from the Lead wire of Ignition coil (Fig. 1).
(2) Remove Air cleaner cover and disconnect control cable from the swivel of carburetor.
Remove Control cable from cable bracket (Fig. 2).
(3) Remove three bolts to separate engine section. Grounding lead wire is fastened with one of the three bolts (Fig. 3).
Fig. 1
Bullet terminal
Fig. 3
Grounding lead wire
ASSEMBLING
(1) Assemble engine section to the Gear housing.
Note 1; Do not to pinch the Lead wires between Engine section and Gear housing.
Note 2; Make sure to fasten the terminal of Grounding lead wire with one of three Hex socket head bolts.
(2) Fix Control cable along with Adjust screw in the Cable bracket by clamping it with a Nut.
Hook the Control cable end on the Swivel of Carburetor.
Note; Adjust the Cable tension with a 1 - 2 mm play.
(3) Connect Bullet terminals (Fig. 1).
Fig. 2
Control cable
P 3/ 26