Advertisement
Quick Links
HEDGE TRIMMER
EH 450
EH 620
INSTRUCTION MANUAL
.
WARNING:
To reduce the RISK of injury, user must read and understand
the instruction manual before using the Hedge Trimmer.
.
Manufacturer
reserves
the right to change specifications
without notice.
Specifications may differ from country to country.
Do only hand over the Hedge Trimmer together with this manual.
Advertisement
Related Manuals for Makita EH 620
Summary of Contents for Makita EH 620
- Page 1 To reduce the RISK of injury, user must read and understand the instruction manual before using the Hedge Trimmer. reserves Manufacturer the right to change specifications without notice. Specifications may differ from country to country. Do only hand over the Hedge Trimmer together with this manual. EH 450 EH 620...
- Page 2 Thank you very much selecting the MAKITA Hedge Trimmer. We pleased to able offer you the MAKITA Hedge Trimmer which the result of a long development program and many ears of knowledge and experience. The Hedge Trimmer models EH450/620 combines the advantages of...
- Page 3 Gloves m a d e of thick leather are part of the prescribed equipment and must always b e worn during operation When using the Hedge Trimmer, always wear sturdy s h o e s with sole. non-slip This protects against injuries and ensures a good footing.
- Page 4 Stop the engine during transport (7). Secure the tool properly before transporting in vehicle to avoid fuel leakage. W h e n transporting the Hedge Trimmer ensure that the fuel tank leakage. completely empty to avoid fuel Refuelling of fire and bum injury; handle fuel with care. It...
- Page 5 Observe and follow all relevant accident prevention instructions issued by the trade associations safety boad and by insurance companies. D o not perform any modific;rtions to the Hedge Trimmer a s this will risk your safety. The performance of maintenance or repair work by the user is limited to those activities as done by Makita authorized Factory Service Centers.
- Page 6 Clutch engagement speed Carburetor type Ignition system Spark plug Electrode g a p Mixture ratio (fuel : MAKITA 2-stroke oil) Gear ratio T h e data takes equally into account idling and racing speed operating modes. the cuttina protective cardboard is.a...
- Page 7 NAME OF MAJOR PARTS E H 4 5 0 NAME OF MAJOR PARTS Blade Front handle Recoil starter Fuel tank cap Carburetor STOP Switch (ON-OFF) E H 6 2 0 NAME OF MAJOR PARTS Throttle lever Rear handle Muffler Gearbox Blade cover...
- Page 8 (MAKITA 2-stroke engine 50:l function the Hedge Trimmer cannot be guaranteed. The correct mixture ratio: part MAKITA 2-stroke engine oil (See parts gasoline with table on the right) For preparing the fuel-oil mixture, first mix the entire NOTE quantity with half the fuel required.
- Page 9 Before u s e always check that the Hedge Trimmer is safe for operation. Check the cutting device is not damaged, the control lever e a s y action and check for proper function of the STOP switch.
- Page 10 STARTING THE MACHINE Move a t least meters away from the place Hedge Trimmer on clean a r e a ground make sure that the cutting tool d o e s not c o m e into contact with the ground or any other objects.
- Page 11 The Hedge Trimmer must not b e used for cutting with fast idle. The cutting speed cannot b e adjusted with the throttle control in fast idle position.
- Page 12 Beware the teeth Clean the Hedge Trimmer at regular intervals and check that Never service store the Hedge Trimmer in the vicinity of naked flames to avoid fires. Always wear leather gloves when handling Blade sharpening...
- Page 13 Checking and adjusting t h e idling s p e e d cutting blade should when the control lever speed should be s e t to rpm. Idle 2,600 If necessary, correct it by means the idle screw (the cutting blade must not run when the engine i s on idle).
- Page 14 (Daily) Before operation, always check for clogging Perform the following work daily after use: Clean the Hedge Trimmer externally and inspect for damage. Clean the air filter. When working under extremely dusty conditions, clean the filter several times Check the for d a m a g e and make sure they a r e firmly mounted.
- Page 15 STORAGE MAINTENANCE SCHEDULE Engine assembly, General screws and nuts Throttle lever After e a c h refuelling Safety lock key STOP switch Air filter Daily Cooling air duct Cutting tool Idling speed Every 15 hours G e a r c a s e Spark plug Weekly Muffler...
- Page 16 Your are responsible for presenting your utility and/or lawn and garden equipment engine to a Makita U.S.A., Inc. service center as a problem exists. The warranty repairs should completed in a reasonable time, not to exceed...
- Page 17 LIMITED WARRANTY Makita U.S.A., Inc. a distributor of utility and lawn and garden equipment in the warrants to the owner of 1995 engines that the engine h a s been designed, built, a n d equipped a t the time of...
- Page 18 When a n engine is being serviced under warranty, Makita U.S.A., Inc. and a n y of its authorized dealers, distributors, or warranty stations shall not...
- Page 19 HOW TO FILE A WARRANTY CLAIM AND WHERE TO GET WARRANTY SERVICES Contact the nearest Makita Factory Service Center Manager to determine the appropriate location where the required warranty services are to Service Center locations and phone numbers are provided below for your convenience.
- Page 20 EPA regulations during its warranty period. For the components listed under PARTS COVERED, Makita Factory Service Center or service center authorized by MAKITA diagnosis, repair, replacement necessary to ensure that the engine complies with applicable U S .
- Page 21 A s the engine owner, you should however be aware that the MAKITA may deny your warranty coverage your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.
- Page 22 Service Center service center authorized by MAKITA. emission-related part i s found to notify Makita Warranty Service Department a t 1-800-4-MAKITA and you will b e given the appropriate warranty service facilities where the warranty repair can maintenance of the proper arise.
- Page 23 ..................................
- Page 24 WARNING: The Engine Exhaust from this product contains chemicals known to the state reproductive harm. of California to c a u s e cancer, birth defects or other Makita Corporation 3-11 Sumiyoshi-cho, 446-8502, Japan Anjo, Aichi 51 99501 700 99.5...