Makita EH5000W Technical Information page 12

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -6. Ignition
DISASSEMBLING
Fly Wheel
Note: Plug cap has to be removed in order to avoid accidental start of engine.
Do not remove Plug when the nut for tightening Fly wheel is loosened to utilize air resistant in Cylinder.
(1) Attach 10 mm Hex socket bit to Impact driver. Turn M6 Hex nut counterclockwise with a Impact driver
(Clutch is removed by turning clockwise) (Fig. 23).
Fig. 23
Clutch side
(2) Set 1R364 to Fly wheel to Fly wheel with two M6 bolts. Tighten Both of two M6 bolts to the same depth.
Fig. 24
M6 Bolt
Turn Hex nut counterclockwise.
So the Hex nut can be removed.
Clutch is removed by
turning clockwise.
1R364
Piston
Clutch
P 12/ 26
Hex Nut
Fly wheel