Makita EH5000W Technical Information page 2

R
epair
CAUTION: Repair the machine in accordance with "Instruction manual" or "Safety instructions".
< Note in repair>
* Repair the tool always with gloved hand
* Blades must be covered by Blade cover
* Cool down the engin first before repairing to avoid a skin burn.
* Remove all fuels from fuel tank and carburetor. Avoid any fire from the work shop.
* Repair the tool on the stable work table and keep dust out.
* Record where and how the parts were assembled to avoid mis-assembling.
Assort and reserve the dismantled parts in the box by section.
* The dismantled parts must be treated carefully and washed clean before reassembling.
* Use Impact driver in case bolts or screws can not be loosen by hand.
* The bolts or screws must be tightened to the designated fastening torque.
* Check the movement, sound and alignment of the main parts just after assembled.
* Replace the removed gasket with the new one.
[1] NECESSARY REPAIRING TOOLS
Code No. Description
1R024 Press tool
1R127 Air density tester
1R170 T type hex wrench 3-127
1R171 T type hex wrench 4-130
1R229 1/4" hex shank bit
1R364 Fly wheel puller
1R366 Feeler gauge set
1R371 Clutch removing tool
1R373 Clutch drum removing tool
1R374
Pinion gear holding Jig
Hex socket bit 10
Wire brush
[2] LUBRICATION
Apply Makita Grease N. No.2 to Spiral spring for recoil starter (approx. 2g) and Gear room (approx. 40g).
removing Spur gear 9
checking air leakage in Carburetor
removing / tightening M4 Hex socket head bolt
removing / tightening M5 Hex socket head bolt
removing / tightening Engine section
removing Fly wheel
adjusting a proper gap of ignition coil, Spark plug, Shear blade assembly
removing Clutch
removing Clutch drum
fixing Spur gear 9
removing Fly wheel
cleaning Spark plug
Used for
P 2/ 26