Installing The Canopy - KDK R56SV Operating And Installation Instructions

This product should be installed with a double poles single throw switch (Breaker Switch) with minimum 3 mm contact gap in the fi xed
installation circuit.
Do not use regulator or dimmer switch. (It can damage the Ceiling Fan)
此產品必須在固定安裝電路上裝上觸點間隙為最少 3 毫米的雙極單投開關（斷路開關）。
切勿使用調節器或調光開關。（這會損壞吊扇）
Should there be a regulator or dimmer switch, disconnect it and reconnect the wiring as below.
若有調節器或調光開關，請按照下圖拆除然後重新連接。
Regulator / 調節器
Installing the canopy / 安裝罩蓋
C)
1 Separate the Canopy by loosen the 2 Screws provided.
1
鬆開 2 枚配備的螺絲分開罩蓋。
Remove the Screws / 拆開螺絲
Take the Canopy (2 pieces) and clip it until the "click" sound is heard.
2
2
拿起罩蓋（ 2 片）並夾住直至聽到"滴答＂一聲。
Canopy /
罩蓋
ATTENTION / 留意
0 0
1 1
5 5
4 4
2
3
Regulator / 調節器
Power Supply / 電源
Connect Directly /
直接連接
Canopy / 罩蓋
Screw /
螺絲
Canopy rib /
罩蓋凸緣
Dimmer Switch / 調光開關
Power Supply / 電源
Connect Directly /
直接連接
Dimmer Switch /
調光開關
Press / 按
Click /
滴答聲
8
Pull / 拉
ATTENTION / 留意
Make sure both Canopy Rib fi x
into the same level of Canopy Slot
for both side.
確保兩邊的罩蓋凸緣切入對邊相對
的罩蓋凸緣。