KDK R56SV Operating And Installation Instructions page 11

After 4 Blades have been fi xed, fi x the Decoration Cap. Make sure guide at Motor Unit and Decoration Cap are aligned ( ) .
2
2
Turn Clockwise until a click sound is heard ( ).
4 片扇翼安裝完畢后，安裝裝飾蓋。 確保發動機和裝飾蓋在 (
Turn Clockwise /
向順時鐘方向旋轉
Decoration Cap /
裝飾蓋
Fix Decoration Cap in proper condition.
Can cause Decoration Cap drop or abnormal noise.
Can cause injury if decoration cap drops
將裝飾蓋安裝在適當的位置。
這可以導致裝飾蓋掉落或噪音。
若裝飾掉落會導致受傷。
If the Ceiling Fan is found to wobble during operation, fi x the Blades at different combination of position. Repeat this step
until the Ceiling Fan stop wobbling.
如吊扇操作時搖晃，請以不同位置組合安裝扇葉。重復該步驟，直到吊扇停止搖晃。
If Ceiling Fan still wobbles after Step 3, please refer to service or sales agent.
如執行步驟 3 後吊扇仍然搖晃，請聯絡維修或銷售代理。
Check Point After Installation / 組裝後的檢驗點
1. Ensure Decoration Cap marking and Motor Assembly marking is align at position as
shown.
確保裝飾帽上的標記和發動機組件上的基準標記在所示的位置對齊。
Install Remote Control Holder / 安裝遙控器固定器
E)
Fix the Remote Control Holder to wall as shown.
 The Wall Plugs are not needed for wooden walls.
STEP 3
步驟 3
Screw / 螺絲
STEP 4
步驟 4
ATTENTION / 留意
Remote Control Holder / 遙控器固定器
STEP 2
步驟 2
30 mm
30 毫米
Remote Control Holder
遙控器固定器
) 點對齊。向順時鐘方向旋轉直至聽到「滴答」聲 (
OPEN
LOCKED
CAUTION / 注意
如圖所示將遙控器固定器安裝在牆壁上。
 木墻不需使用牆壁插座。
STEP 1
步驟 1
Wall Plug
牆壁插座
BRICKS WALL
磚墻
11
Motor Unit and Decoration Cap align at (
Decoration Cap is opened.
Motor Unit and Decoration Cap align at (
Decoration Cap is locked.
發動機和裝飾蓋在 ( ) 點對齊。
裝飾蓋被打開。
發動機和裝飾蓋在 ( ) 點對齊。
裝飾蓋被鎖定。
Hole Diameter
Ø 6 mm
洞孔直徑 6 毫米
) 。
).
).
Check / 檢查