Panasonic KX-TDA100 Installation Manual page 221

Notice
1.
During a long programming session, it is highly recommended that you periodically save the
system data to the SD Memory Card. If the Hybrid IP-PBX undergoes a sudden power failure or if
the system is reset for some reason, all the system data in RAM will be lost. However, if system
data has been saved to the SD Memory Card, it can be easily restored.
To save the system data to the SD Memory Card, (1) click the "SD Memory Backup" icon before
resetting the Hybrid IP-PBX or turning off the power, or (2) exit the KX-TDA Maintenance Console
so that the Hybrid IP-PBX automatically saves the system data.
3.3 Installation of the KX-TDA Maintenance Console
5. a.
Click the check box to connect to the Hybrid IP-PBX.
Options will appear as shown here, on the left.
b.
Enter the system password for installer (default:
1234).
c.
Select "USB", then click OK.
Note
To connect to the Hybrid IP-PBX via USB, the KX-TDA
USB driver must be installed on the PC, as explained
above in "Installing the KX-TDA Maintenance
Console".
6. When country/area data do not match:
a.
Click OK to replace the country/area data of the
Hybrid IP-PBX. Replacement may take several
minutes to complete.
b.
Follow the procedure described in "2.13.1 Starting the
Hybrid IP-PBX" and restart the Hybrid IP-PBX.
c.
Repeat step 4 to reconnect the KX-TDA Maintenance
Console to the Hybrid IP-PBX.
7. Follow the instructions of the Quick Setup wizard and
assign the basic items (Quick Setup).
The system menu appears. You may now begin
programming the Hybrid IP-PBX.
Installation Manual 221