3. Installation
3.5
Connections
3.5.1
Power connection
AC power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet.
Plug the female power connector into the male connector at the front of the projector.
Fuses
For continued protection against fire hazard :
•
refer replacement to qualified service personnel
•
ask to replace with the same type of fuse.
3.5.2
Input Source connections
Overview
•
Input section
•
Input facilities
•
5-Cable input
•
Composite Video Input
•
S-Video input
•
Digital Visual Interface (DVI) input
•
Computer input
•
Serial Digital Interface (Optional)
•
Audio input/Output (Optional)
•
Communications Connections
3.5.2.1
Input section
Input Layers
The input section is divided in layers, each of them regrouping several inputs, this architecture allows the input section to be upgraded
at any time with an optional analog or digital layer.
1.
Layer 1: analog layer containing analog data and video inputs
2.
Layer 2: a hybrid layer containing 2 digital and 1 analog input
Layer 3 : is an optional layer, it may be an Audio & Video analog layer or a SDI digital layer
3.
3.5.2.2
Input facilities
overview
•
5–cable input
•
composite video
•
component video (PR/Y/PB)
•
S-Video
•
Digital Visual Input (DVI)
•
Computer
•
Serial Digital Input (Optional)
•
Audio input/output (Optional)
14
Downloaded From projector-manual.com Barco Manuals
The power input is auto-ranging from 90 to 240 VAC.
The optional features are also explained in this manual, they are always mentioned with "(optional)"
R5976837 BARCO ID R600/R600+ 21/09/2006