Barco ID R600 Owner's Manual page 57

Note that native resolution refers here to the source and does thus only have sense when handling data sources (greyed out for
video sources).
Depending on the type of projector the "show native resolution" function will handle the sources as follows:
Source
Name
xga
sxga
sxga+
uxga
Table 6-1
Show native resolution = ON
How to enable the "Show native resolution" function?
1. Press MENU to activate the Tool bar
2. Press → to select the Image item
3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select Show native resolution (image 6-28)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select On
7. Press ENTER
A white bullet shows the selection
Image 6-28
R5976837 BARCO ID R600/R600+ 21/09/2006
Downloaded From projector-manual.com Barco Manuals
Ratio Resolution
4:3 1024x768
5:4 1280x1024
4:3 1400x1050
4:3 1600x1200
The Full screen representation function on the other hand forces to use the complete native resolution of the
LCD panels.
The default mode is used if the Show native resolution and the Full screen representation are off.
The default mode shows always the native ratio and forces the native resolution of the panels (part of the
image blanked where needed)
When show native resolution is ON and the resolution of the source is higher than the panel resolution , use
the arrow keys to scroll through the image (pan).
Projected image
Ratio Resolution
4:3 1024x768
5:4 1280x1024
4:3 1400x1050
4:3 1600x1200
6. Advanced
Display
image centered +side blanked
image centered +side blanked
image centered
scroll image
53