Table of Contents
Advertisement
Air blow direction
Exhaust fans 1 and 2
After replacing the DMD, if shading is present on the screen as shown in Figure 1, adjust the lighting area of the
DMD by turning the adjustment screws for the optical engine.
1. Loosen the fixing screw for the adjustment lever 1. Adjust the lighting area by adjustment lever 2 and
then tighten the fixing screw for the adjustment lever 1.
2. If the above adjustment is insufficient, loosen the fixing screw 3 and set the adjusting screws 4 and 5.
Finally tighten up the fixing screw 3.
3
1
When mounting the DMD element,
tighten the four screws evenly.
When removing a projection lens, please change the setting of Iris to "high contrast" beforehand.
2
4
Tightening order: 1
2
3
Screw tightening torque: 0.78±0.1 N-m
25
4
Fig. 1
EIP-3500
Shading
Advertisement
Table of Contents
