Table of Contents
Advertisement
Maintenance indicator
Normal
Temperature
warning
Off
indicator
Green on
Green blinks
when the lamp
Lamp
is warming up
indicator
or shutting
down.
Info
If the temperature warning indicator illuminates and the projector enters the standby mode, check whether
any of the ventilation holes are blocked and then try turning the power back on. Wait until the projector has
cooled down completely before plugging in the power cord and turning the power back on.
(At least 10 minutes.)
If the power is turned off for a brief moment due to power outage or some other cause while using the
projector, and the power supply recovers immediately after that, the lamp indicator will illuminate in red
and the lamp may not be lit. In this case, unplug the power cord from the AC outlet, replace the power
cord in the AC outlet and then turn the power on again.
Do not unplug the power cord after the projector has entered the standby mode and while the cooling fan
is running. The cooling fan runs for about 90 seconds.
Problem
Abnormal
Abnormal
The internal
Red on
temperature is
(Standby)
abnormally high.
The lamp does
not illuminate.
Red on
Time to change
the lamp.
Red on
The lamp does
(Standby)
not illuminate.
Cause
Relocate the projector to an area
with proper ventilation
Blocked air intake
Take the projector to your nearest
Cooling fan break-
EIKI Authorized Projector Dealer
down
or Service Center for repair.
Internal circuit failure
Clean the exhaust and intake
Clogged air intake
vents.
Disconnect the power cord from
The lamp is shut
the AC outlet, and then connect it
down abnormally.
again.
Carefully replace the lamp.
Remaining lamp life
becomes 5% or less.
Take the projector to your nearest
EIKI Authorized Projector Dealer
or Service Center for repair.
Burnt-out lamp
Please exercise care when
Lamp circuit failure
replacing the lamp.
23
EIP-3500
Possible solution
Advertisement
Table of Contents
