Connecting The I2022- Auto-Install - Nortel i2022 Series User Manual

Example:
Press the softkey under Directory - shown below by highlighting (bold type) the word "DIR" and highlighting the softkey
below that menu item.
Pressing the Directory softkey brings up the second menu with additional choices. In our example we chose Search next -
shown in bold type. The selected menu items are shown in bold type for emphasis. The softkey under Search is
highlighted to indicate the chosen softkey.
Choosing Search returns the next screen, assuming the Directory is empty.
To return to the main menu at any time, press the MENU hardkey.

CONNECTING THE i2022- AUTO-INSTALL

1. Assemble the i2022
NOTE: Make sure the logo plate is installed
2. Verify the PS1/PS2 switch located on the Interface Module is in the PS2 position. See page 6 for further
information on setting the PS1/PS2 switch.
3. Verify the Terminating Resistor (TR) switch is set correctly. See page 8 for further information on setting the TR switch.
4. Connect one end of the eight-pin mounting cord to the ISDN Line-In jack on the rear of the Teleset's Interface
Module. Connect the other end of the cord to the S/T jack on your NT1 or ISDN telephone wall jack.
5. Remove the protective film on the display.
6. Label and install the designation card
AUTO-Install
The i2022 is equipped with an Auto-Install feature. The purpose of Auto-INSTALL is to ensure a complete and painless
installation. In this mode, the i2022 will first detect the type of switch the i2022 is connected to, and then will attempt to
Auto-SPID. The switch will automatically download the features. The i2022 will then step through each of its programming
choices and give you the opportunity to make a selection. After you have made the selection press the "MORE" key to
continue.
i2022 ISDN Teleset
Setup
13