Nortel i2022 Series User Manual page 19

4. Up to twenty digits can be entered as the SPID. After entering the digits, press Save to enter into non-volatile
memory. If an error is made use the Bkspc (backspace) key to edit. Enter the corrected digits and press Save.
5. Choose the Service you require. (Voice is the default) See Table 4.
Serviced as Voice
SPID1 = 84755547360101
[(P+D)=POTS+Data]
(P+D) Data
POTS
Press MENU to exit.
When the SPID entry is complete, the Teleset must be programmed.
The i2022Teleset can download the switch parameters, and/or can be manually programmed.
Manual Switch Downloading
Switch parameters may be downloaded from the switch to the Teleset over the ISDN line. A download can be requested
up to three times in a five-minute period. To download proceed as follows:
1. Press MENU, MORE, MORE, Config, MORE, MORE, and ReqParam/RunSPM (depending on the switch) in order. A
message indicates a successful or failed download. If the switch is in the Auto-SPID/Auto-Switch mode, the download
is automatic upon initialization. If successful, the remainder of the setup parameters need not be entered. These setup
characteristics include conference, drop, transfer and Call Appearances. You must enter these parameters manually if
the download fails. Press MENU to return to the idle (power-up) screen.
NOTE: If the Teleset detects a DMS-100
be displayed as RunSPM.
NOTE: If the Teleset has not linked with the switch, the display will show "Layer 3 Not Initialized", "Data Link Down"
or "Line Not Ready".
NOTE: Parameter Downloading applies to SPID 1 only.
i2022 ISDN Teleset
MORE is flashing
or the switch is programmed as a DMS-100
®
17
, the ReqParam softkey will
®