Install Your Meridian/Succession Cse 1000 I2004 Internet Telephone - Nortel Meridian/Succession CSE 1000 i2004 Instruction Manual

Install your Meridian/Succession CSE 1000 i2004 Internet Telephone

Install your Meridian/Succession CSE 1000 i2004
Internet Telephone
Connect the i2004 telephone components:
1
2
3
Severe damage to your i2004 telephone will occur if this set is
plugged into an ISDN connection. Consult your system
administrator to ensure that you are plugging your set into a
10/100BaseT Ethernet jack.
4
5
6
Configure the software and firmware
Refer to the ITG Line 2.1/i2004 Internet Telephone Description, Installation
and Operation (553-3001-204) for instructions on configuring the software
and firmware.
6
Connect one end of the handset cord to the handset jack
on the back of the telephone identified with a handset icon.
Connect the other end of the handset cord to the handset.
Connect one end of the CAT-5 line cable to the ethernet
jack on the back of the telephone. The other end plugs into
the IP voice network (ethernet), using a RJ45 connector.
CAUTION
Plug the AC Power adapter into the connection on the
back of the telephone. Be sure to thread the cord around
the strain relief, retaining hook and channel provided for a
secure power connection.
Secure the telephone footstand to the base of the
telephone. Use the angle adjustment grip on the top back
of the telephone to adjust the position.
Do not attempt to power-up your i2004 telephone. Your
Nortel Networks installation technician must complete this
procedure.