Event Messages - Nortel Companion MICS-XC Installation Manual

Nortel networks companion installation guide
Table of Contents

Advertisement

100 / Troubleshooting

Event messages

Event message display
Evt:275-3546
Evt:301-1031
Evt:302-1031
Evt:303-1031
Evt:304-1032
MICS-XC Norstar-Companion Installer Guide
(U.S. only) Unable to activate all registered
S8
portables. The system ran out of portable credits.
One event is generated per portable that failed to
activate. The repetition of the corresponding alarm
code 59 indicates how many additional credits must
be purchased.
The Base Station (on port 0103 in this case) cannot
S5
successfully receive the data image.
Both radios belonging to the Base Station are
disabled. This may occur if the flash EEPROM is
faulty. Two events are raised: one for the B1
channel radio (as in this case) and another for the
B2 channel radio. A corresponding alarm code 53
occurs.
The Base Station (on port 0103 in this case) cannot
S5
be written to during data transfer.
Both radios belonging to the Base Station are
disabled. The Base Station's flash EEPROM is
faulty. Two events are raised: one for the B1
channel radio (as in this case) and another for the
B2 channel radio. A corresponding alarm code 53
occurs.
The Base Station (on port 0103 in this case) cannot
5
be synchronized with the other Base Stations in the
system.
Both radios belonging to the Base Station are
disabled. The Base Station hardware is faulty. Two
events are raised: one for the B1 channel radio (as
in this case) and another for the B2 channel radio.
A corresponding alarm code 53 occurs.
A B2 channel radio (radio 2 on port 0103 in this
case) cannot be synchronized with other radios
because of system overload.
Cause
P0881594 Issue 01

Advertisement

Table of Contents
loading

Table of Contents