Table of Contents
Advertisement
84 / Registering individual portables
Measuring directed RSSI using your portable
1. Perform an undirected Receive Signal Strength Indicator
by following steps 1 to 3 in "To measure undirected
RSSI'' on page 77. To direct the Receive Signal Strength
Indicator to the other radio of the Base Station, move out
L
of range until hand-off occurs before moving on to step 2.
* 8 9 9
2. Press
3. Press
4. Enter the five-digit ID code for the Base Station radio you
want to measure. The display shows this ID followed by
the signal strength, for example 03121 - 67. If you have
not established a connection with the desired Base Station
radio, you hear a tone when you hold the portable to your
ear.
5. Read your measurement. The system drops the link when
you move out of range of your Base Station (no hand-off).
6. To end the connection, press
After registering the portables
When you have completed programming the system, use the
following checklist to ensure you completed the required
tasks.
å
Register the portables.
å
Verify Portable Credits.
å
Ensure that you registered all the required portables.
å
Verify that all portables are available for use.
å
Test each portable to verify it is operating properly.
å
Disable Master Registration when you have finished
registering the portables.
MICS-XC Norstar-Companion Installer Guide
. Wait for dial tone.
.
r
, or close the flap.
P0881594 Issue 01
Advertisement
Table of Contents
