Setting The Speaker Balance; Downmix Function (Aspen Ivdm-7003) - Blaupunkt Aspen IVDM-7003 Operating Instructions Manual

AUDIO setup menu

Setting the speaker balance

1. Touch the button on the touch screen menu and
Setup Setup
then touch the button.
2. Touch the button.
✔
The "Audio Effect Control" AUDIO submenu is displayed.
Audio Effect Control
Audio Effect Control
ProLogic2 ProLogic2 OFF OFF
SFC
SFC OFF OFF
DownMIX DownMIX OFF
BALANCE
BALANCE
FADER
FADER
NEXT NEXT
3. Touch "BALANCE" (volume distribution left - right) or
"FADER" (volume distribution front - rear) to activate it.
4. Repeatedly touch the left or right area of the scale to
adjust the volume distribution.
5. To confirm the setting, touch the
6. Repeat steps 3 - 5 to perform additional settings, or
6. touch the button to exit the menu.
EXIT
EXIT
ProLogic Music
Studio Hall Church
Stereo Stereo Lt/Rt
+0 +0
+0 +0
EXIT EXIT
button.
EXIT EXIT

Downmix function (Aspen IVDM-7003)

The downmix function in the audio setup's "Audio Effect Control"
submenu is used to control the downmix mode for the audio/vid-
eo outputs (VIDEO 1 OUT, VIDEO 2 OUT) and loudspeaker/
preamp outputs.
The downmix function on the remote control is used to control
the downmix mode for the loudspeaker/preamp outputs. If the
downmix mode is activated using the DOWNMIX button on the
remote control, this will have the same effect as deactivating
("OFF" setting) the centre loudspeaker and subwoofer in the au-
dio setup's "Speaker Setup" submenu.
Since the Aspen IVDM-7003 is equipped with only one digital
signal processor (DSP), the downmix function for the audio/vid-
eo outputs and for the loudspeaker/preamp outputs cannot be
configured independently of one another.
Note: If the downmix function has been deactivated
("OFF" setting) in the audio setup's "Audio Effect
Control" submenu and a signal source is selected that
has been encoded using the Dolby Digital 5.1 or DTS
5.1 process, there will be no centre sound informa-
tion present at the audio outputs of VIDEO 1 OUT and
VIDEO 2 OUT. In order to indicate that this configura-
tion does not make sense, the system mutes the au-
dio outputs of VIDEO 1 OUT and VIDEO 2 OUT. On the
Aspen IVDM-7003, it therefore only makes sense to
deactivate the downmix function if an external ampli-
fier and a centre loudspeaker are being used with the
system.
Note: For the Aspen IVDM-7003, downmix can be set
only if you called the setup menu in DVD mode. The
setting affects only the DVD mode.
62